Brahma 37201350 MPI23 control box

Brahma MPI23 37201350 control unit – control of burners with forced draft, mixed fuel. New product, one control unit, non-volatile locking, air flap control. It is suitable for multistage and modulating burners in domestic and industrial heating.

General characteristics

• Flame control using flame straightening (ionization) properties or UV1 type ultraviolet phototubes (technical specifications are specified in the relevant technical data sheets).

• Two independent safety contacts for controlling the gas valve.

• The service life of electrical equipment is more than 250,000 operations at the maximum declared load.

• Built-in and/or remote manual reset with liquid crystal indication of the reasons leading to an emergency shutdown.

• The ability to control the valve inspection system at the pre-purge stage or after purging.

• Easy to install and connect.

• The possibility of multiple ignition attempts depending on the end use.

• Operating cycles compatible with the LFL1 type controller (Siemens). When replacing the control unit, the outlet must also be replaced.

Technical specifications

Power supply: 230 V (+10%/-15%) – 50/ 60 Hz; on request: 110/120 V (+10%/-15%) – 50/ 60 Hz

Operating temperature range: -20°C + 60°C

Ambient humidity: no more than 95%

Degree of protection: IP40

Classification codes:

according to EN 298:03 FBLLXN

according to EN 230:05 FTLLXN ”WLE”

Power consumption at startup: 7.5 VA

Power consumption during operation: 9 VA

The presence of a base: no

Pre-ventilation time (TV/tp): 31.5 sec

Safety time (ts): 3 sec

Tightness control of gas valves: yes

Weight: 0.95 kg

Dimensions: 10.3×10.3×9.1 cm

Construction

The use of special manufacturing technology and the introduction of SMT technology have made it possible to obtain an extremely flexible device that can control the air flap. The plastic housing protects the control panel from any damage resulting from accidents, careless handling, dust and dirt ingress. The varistor protects the control panel from power surges in the network. A built-in fuse protects the internal control relays in the event of a short circuit at the outputs (gas valves, motor, transformer and lock signal). Since this is not an emergency fuse available, the Brahma MPI23 37201350 control unit must be protected by an external high-speed fuse suitable for connected loads and not exceeding 6.3A.