Brahma 15930000 TCD1BA ignition transformer

BRAHMA TCD1BA 15930000 ignition transformers are characterized by extremely compact overall dimensions. They are used in gas burners, burners for light and heavy types of liquid fuels in both domestic and commercial as well as industrial installations.

The principle of operation is based on a high-frequency electronic generator; the voltage produced by it increases due to the use of a transformer with a ferritic core, reaching output values of 17 kV.

All BRAHMA TCD1BA 15930000 transformers with ignition cable have a filter and comply with the requirements of Directive 2004/108/EC without the use of additional external filters.

Specifications

• Built-in EMC filter;
• The dimensions allow you to replace most transformers from other manufacturers ;
• The dimensions correspond to the transformers of the TC and TD series manufactured by Brahma;
• High efficiency and ignition power;
• Low power consumption;
• Single or double-pin high voltage output;
• Various mounting and connecting systems;
• Built-in short circuit protection;
• In gas and liquid fuel burners, the safety of ignition transformers depends on the controller.

Permissions

BRAHMA TCD1BA 15930000 ignition units meet the requirements of the Low Voltage Directive (LVD) 2006/95/EC, as they have an IMQ resolution in accordance with EN 61558-1:2005+A1:2009 and EN 61558-2-3:2010 standards.

Technical information

Number of contacts: 1

Peak output voltage kV: 17

Rated output voltage kV: 6

Peak current mA: 83

Rated current mA: 37

kHz output voltage frequency (1): 7

kHz output voltage frequency (2): 13

VA Energy Consumption: 31

Supply voltage: 230 V 50/60 Hz

Duty cycle: 33%

Operating temperature: -20 … +60 °C

Protection: IP 00

Recommended spark distance: 3-5 mm

Max. length of ignition cable: 1.5m

Weight: about 250 g.

Construction

The principle of operation based on the use of a high-frequency electronic generator made it possible to create a device of compact dimensions and low weight, but with high ignition power. The electronic circuit and the BRAHMA TCD1BA 15930000 transformer with a ferritic core are treated with a special composition with high thermal conductivity and a special expansion coefficient, which provides protection against temperature fluctuations and overloads caused by prolonged operation. The built-in varistor protects the device from possible power surges in the power supply network.

Connections

BRAHMA TCD1BA 15930000 transformers can be supplied with a triangular connector SP1 for connecting the power cable, or with a connector 6.35×0.8; Cable length and end can be changed on request.

The connection of the high-voltage cable is available in 2 versions: connection with an ø4 mm connector or a threaded connection. All connectors, including connectors with cable, are available on request.

Installation

• ATTENTION! HIGH VOLTAGE.
• Connect and disconnect the transformer only after the power is turned off.
• The installation is carried out in accordance with national and European standards (e.g. EN60355-1 / EN50165) for electrical safety.
• The installation must ensure that the valve body is connected to the ground to provide protection against electric shock. – The transformer is installed in any position.
• Do not place high-voltage cables next to other cables.
• Ensure the appropriate level of protection for this installation.