Brahma 15910658 TC2LTCSF 110-120V ignition transformer

BRAHMA TC2LTCSF 15910658 ignition transformers are characterized by ultra-compact overall dimensions and are widely used in gas burners, as well as burners for light and heavy liquid fuels used in both domestic and commercial and industrial installations. They operate on the basis of a high-frequency electronic generator, where the voltage is increased by using a high-voltage transformer BRAHMA TC2LTCSF 15910658 with a ferritic core, reaching output values up to 15 kV.

All variants of BRAHMA TC2LTCSF 15910658 transformers with ignition cable can be supplied with a filter to reduce electromagnetic interference. In the presence of such a filter, the electronic transformers comply with the requirements of Directive 2004/108/EC, and the use of additional external filters is not required. The BRAHMA TC2LTCSF 15910658 ignition units also offer versions for continuous operation with a 50% duty cycle for 2 minutes.

Specifications

• The possibility of delivery with an integrated EMC filter;
• 100% duty cycle;
• Light weight and compact size;
• High efficiency and ignition power;
• Low power consumption;
• Single or double-pin high voltage output;
• Various mounting and connecting systems;
• Built-in short circuit protection;
• In gas and liquid fuel burners, the safety of ignition transformers depends on the controller.

Technical information

Number of contacts: 2;

Peak output voltage: 2*12 kV;

Peak current: 55 mA;

Output voltage frequency (1): 8.5 kHz;

Output voltage frequency (2): 12 kHz;

Power Consumption: 30 VA;

Supply voltage: 220-240 V 50/60 Hz (can be on request: 110-120 V 50/60 Hz);

Duty cycle: 100%;

Operating temperature: -10 … +60 °C;

Protection: IP00;

Recommended spark distance: 3-5 mm;

Maximum length of ignition cable: 1.5 m;

Standard power cable length: 560mm;

Weight: about 420 g.

Installation

• ATTENTION! HIGH VOLTAGE.
• Connect and disconnect the BRAHMA TC2LTCSF 15910658 transformer only after the power is turned off.
• The installation is carried out in accordance with national and European standards (e.g. EN60355-1 / EN50165) for electrical safety.
• The installation must ensure that the valve body is connected to the ground to provide protection against electric shock (EN60335-1).
• The transformer is installed in any position.
• Do not place high-voltage cables next to other cables.
• Ensure the appropriate level of protection for this installation.